Rear spring oem reinstall

Rusty

You still have the oem bucket arm installed, or using a SPL arm?

Disconnect the sway bar end link on the arm, and arm at the knuckle, then pull down the arm. Put spring into place. Make sure you have it in there correctly. There is a top and bottom on the spring. Plus the spring sits in the rubber only one way. Slide your floor jack under the arm and start jacking up until you get the arm and knuckle holes aligned up. Install bolt and nut.

Attached Images

rsz_024.jpg (129.7 KB, 15 views)

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

obender66

If spring bucket does not swing freely all the way down, loosen other nut a little bit(the one which is attaching bucket to subframe). Do not remove it.

__________________
2016 370Z Base/Setrab/AEM/Uprev/M7 Japan/Magnaflow/Quaife/Wilwood/300 whp
2003 G35 sedan 6MT(good bye-after 15 years together )