BC ER, SPL Install and Adjust

GSS138 · 02-19-2015, 03:54 PM

Quote:

Originally Posted by sandersd

So I reinstalled the shocks and went to fill up. After I pulled up to the pumps but before I started filling I measured and both sides = 26.5". After I filled up both sides measured 26.5".

Went back home and measured and the 1/2" diff was back. So all that was for nothing. Moral of the story is make sure you have a flat and level area to take your measurements.

Well, at least I am intimately acquainted with my suspension setup.

Similar problem when I was doing this-I have BC BR's and 12k/11k swifts. Some of it can be the surface, also if you let your car down off the lift and don't move it or roll it out, you can expect to lose a good 1/2" once you have rolled out the binding.

Also everytime I have removed the top 3 nuts and put them back on, clunk. I drive it for a day or 2 or 3, retighten the bolts and find I usually have sometimes almost a full turn of play in them.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Lowered, now need to adjust headlights.	Kandy OrangeZ	Exterior & Interior	23	11-09-2022 02:44 AM
How to adjust your clutch pedal Correctly.	Joe@ZSpeed	DIY Section (Do-It-Yourself)	9	04-24-2018 07:15 PM
can only adjust to 2.5 with spc camber kit!!	RyanWest	Brakes & Suspension	25	06-03-2013 08:54 AM
Can't Adjust Idle RPM and Timing in Cipher?	AlphaSnacks	Tuning	4	03-19-2012 12:47 PM
how to adjust ams short shifter??	Dan Z Man	Engine & Drivetrain	6	11-22-2010 09:59 PM