'14 h/u install

Jsmith7861 · 07-26-2014, 09:14 AM

Does no one know?

Nillaz · 07-26-2014, 04:26 PM

Those are the Metra harnesses for the Z (70-7552 and 40-NI22). I remember Big posting a while back that the wiring had changed at some point through 2013, but I don't know if Metra ever released an updated harness.

If that is the case it's not the end of the world, though you might have a little bit of work ahead of you. I don't believe the harness itself has changed, just the pin locations. With a little bit of patience you can use a small screwdriver or the like to relocate the pins to the proper locations.

Nillaz · 07-26-2014, 04:28 PM

Found the original thread here:

Caution with 2013 models and install

Before doing any DIY hacking on your harness I would visually inspect and verify the pinouts on the car side of the harness.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
HFC install	g96818	Hawaii	30	08-11-2013 10:39 AM
PLS Help! 4.08 FD Install?	JC671	Engine & Drivetrain	6	09-21-2012 08:55 PM
Sub install	pokeyl	Audio & Video	23	04-11-2012 05:57 PM
CBE install first, then HFC, or together?	TruKoi	Intake/Exhaust	2	06-15-2011 10:49 PM
my install so far	samb03	Audio & Video	2	03-28-2011 03:44 PM

07-26-2014, 09:14 AM	#1 (permalink)
Jsmith7861 Enthusiast Member Join Date: Nov 2013 Location: Virginia Posts: 466 Drives: 2014 370z Base Sport Rep Power: 12	Does no one know?

07-26-2014, 04:26 PM	#2 (permalink)
Nillaz Enthusiast Member Join Date: Feb 2012 Location: Reading, PA Posts: 259 Drives: 2012 370Z M6 Sport Rep Power: 3370	Those are the Metra harnesses for the Z (70-7552 and 40-NI22). I remember Big posting a while back that the wiring had changed at some point through 2013, but I don't know if Metra ever released an updated harness. If that is the case it's not the end of the world, though you might have a little bit of work ahead of you. I don't believe the harness itself has changed, just the pin locations. With a little bit of patience you can use a small screwdriver or the like to relocate the pins to the proper locations.

07-26-2014, 04:28 PM	#3 (permalink)
Nillaz Enthusiast Member Join Date: Feb 2012 Location: Reading, PA Posts: 259 Drives: 2012 370Z M6 Sport Rep Power: 3370	Found the original thread here: Caution with 2013 models and install Before doing any DIY hacking on your harness I would visually inspect and verify the pinouts on the car side of the harness.