Help l with bose+nav amp and sub install

brancky3 · 06-29-2014, 12:32 PM

Quote:

Originally Posted by Silly Rabbit

If you get an amp with hi level inputs you won't need the remote wire. I tapped into the sky blue and violet wires that run to the sub box in the spare tire. I wired them straight to an Alpine MRV-M500 and it senses when to turn to on. Check the sticky section above for a video on how\where to run the power wire.

That depends on the amp, I had a Kenwood with high level inputs that still required the remote turn on.

Silly Rabbit · 06-29-2014, 02:57 PM

Quote:

Originally Posted by brancky3

That depends on the amp, I had a Kenwood with high level inputs that still required the remote turn on.

This is true. Check the amps specs before assuming the high level is auto sensing. Also if you already have an amp that doesn't have high level inputs, you can use a line output converter (LOC). The LC2i seems to be a favorite. It will take speaker level connections and give you the low level RCA outputs needed.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stereo install with bose audio no nav	Homegrown	Audio & Video	19	06-10-2014 02:44 AM
New install/removal of Bose Sub	Riptide67	Audio & Video	5	02-14-2014 09:43 PM
HELP 2013 nismo with Bose aftermarket sirus xm install	fireman3361	Audio & Video	4	01-21-2014 01:51 PM
Bose install in base model	Tommy G	Audio & Video	16	05-29-2013 05:52 AM
how to install line driver on factory bose amp?	tl1284494730	Audio & Video	3	09-19-2011 11:41 PM