Plug and Play Bypass Kit (DVD, NAV and backup Camera) Discussion

bdl99

I think you will find that is exactly what I posted
The only difference is the diagram is from the harness perspective and mine was from the switch

1 2
3
4
5 6
Mine looking at switch

4 5
2
1
3 6
Diagram from manual looking at harness

1 (3) 2 (6)
3 (1)
4 (2)
5 (4) 6 (5)
Showing both (harness in brackets)

The reason for the metering voltages between (5) and (6) is due to metering before and after the bulb.

wheee!

Actually I think you have it reversed Brian...

Pin 4 is top left on the switch, top right on the harness. It is a black wire (indicating ground I assume) and next to it is pin 5 (red wire) which is 12v constant.

As for 5 & 6, are you saying that that is strictly for the centre "seat" icon to light up? That would make sense too if the LED's for the heat indicators are pulling their voltage from pin 1 (12v)

Sorry if this is becoming semantic at all, just trying to be as clear as possible!

__________________

bdl99

Trust me its right, remember there is also harness side vs terminal side (HS vs TS) in the manual.

Correct the LEDs for switch position are getting there +12V from Pin 1 (pin 3 in my original diagram). The illumination for the center icon is separate.

No problem, for those buying a kit it wont matter for anyone taking the complete DIY approach it will probably need a photo or two