02-01-2010, 03:29 PM
|
#1 (permalink)
|
|
Enthusiast Member
Join Date: May 2009
Location: Florida
Posts: 294
Drives: 2015 Corvette Z51
Rep Power: 20
|
Quote:
Originally Posted by jikhead
On your door molex connector video, here is a tip for others:
Drill a hole like in the video. Then remove the big grommet in the door FROM the door. Put some electrical tape on the tip of the speaker wire to make a smoother point for the wire to snake thru the rubber hose. Start from the door end, and snake the wire from the door thru the hose to the connector. When you do this, try and make the hose as straight as possible. I tried to grab the wire in the hose and help feed it up and thru from the outside. Once I saw the tape, I then used small plyers to grab it and pull it out of the connector. Pull the wire thru and then feed thru the connector on the car that you drilled the hole for. Replace everything and done.
After about 30 minutes of getting nowhere, I tried the above and got it snaked thru in about 10 minutes. This should save you some time.
|
Little tricky to snake it through on the first side you do but it is a couple minute job once you get the hang of it. It really is a short distance to snake the wire and taping it like you suggested is a good tip.
|
|
|
Similar Threads
22Likes
Hybrid Mode
