The Install Videos

jikhead · 02-01-2010, 12:31 AM

On your door molex connector video, here is a tip for others:

Drill a hole like in the video. Then remove the big grommet in the door FROM the door. Put some electrical tape on the tip of the speaker wire to make a smoother point for the wire to snake thru the rubber hose. Start from the door end, and snake the wire from the door thru the hose to the connector. When you do this, try and make the hose as straight as possible. I tried to grab the wire in the hose and help feed it up and thru from the outside. Once I saw the tape, I then used small plyers to grab it and pull it out of the connector. Pull the wire thru and then feed thru the connector on the car that you drilled the hole for. Replace everything and done.

After about 30 minutes of getting nowhere, I tried the above and got it snaked thru in about 10 minutes. This should save you some time.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
check out my track videos	Bushguts	Other Vehicles	5	07-13-2009 09:23 AM
370z vs GT-R - 2 x Youtube videos	chubbs	Nissan 370Z Photos / Spyshots / Video / Media Gallery	3	05-19-2009 01:51 PM
Acceleration Videos	DonWolfo	Nissan 370Z Photos / Spyshots / Video / Media Gallery	4	03-04-2009 12:09 PM
Music~videos	nogoodname	The Lounge (Off Topic)	38	12-16-2008 11:11 PM
More videos from GT channel	Dav	Nissan 370Z Photos / Spyshots / Video / Media Gallery	4	12-03-2008 07:27 PM

02-01-2010, 12:31 AM	#11 (permalink)
jikhead Enthusiast Member Join Date: Jun 2009 Location: Little Rock, AR Posts: 425 Drives: 09 370Z Blue 6spd Rep Power: 185	On your door molex connector video, here is a tip for others: Drill a hole like in the video. Then remove the big grommet in the door FROM the door. Put some electrical tape on the tip of the speaker wire to make a smoother point for the wire to snake thru the rubber hose. Start from the door end, and snake the wire from the door thru the hose to the connector. When you do this, try and make the hose as straight as possible. I tried to grab the wire in the hose and help feed it up and thru from the outside. Once I saw the tape, I then used small plyers to grab it and pull it out of the connector. Pull the wire thru and then feed thru the connector on the car that you drilled the hole for. Replace everything and done. After about 30 minutes of getting nowhere, I tried the above and got it snaked thru in about 10 minutes. This should save you some time.