Install (picture heavy)

pg6speed

First tape the area to be molded
Second put foil over the tape
Third lay fiberglass mat or cloth and resin
Fourth Let the fiberglass harden (completely) and remove mold

__________________
STILLEN G3 / F.I. TDX (NO RESONATORS) / F.I. LTH / UpRev Tuned / BC-Racing ER Coilovers / DIY Oil Cooler / Short Shifter

armensti

thanks for telling me. sounds pretty easy and then you would use sealant to attach it to the wooden part of the box right?

how thick do you make the fiberglass and does it hit as hard as a regular sealed box?

__________________
Shutting down competition one car at a time

pg6speed

I use hot glue to attach the wooden frame to the fiberglass mold and also to glue the fabric to the mold and wooden frame. Spread resin over the fabric and let dry. At this point start adding layers of glass and resin. I do about two to three layers being sure to get any air bubbles out as I go then let dry. Last I add two more layers. The thickness depends on how big the area is and how many curves there are. The longer and flatter the area, the more layers I use. The more curves there are you may be able to get away with less since the curve will add strength. I wouldn't use less than 3-4 layers in any case.
If it is built thick and strong enough with no flex it will sound just as good as any mdf box.

__________________
STILLEN G3 / F.I. TDX (NO RESONATORS) / F.I. LTH / UpRev Tuned / BC-Racing ER Coilovers / DIY Oil Cooler / Short Shifter

armensti

thanks a lot im planing on doing this some time soon. i just need to purchase a higher quality subwoofer and amp. i dont like what i have now

__________________
Shutting down competition one car at a time