upRev questions

Cafiax

If you take your car to a tuner to get it tuned do you have to buy the license for your car prior to going in to do the actual tune? or does the shop own the license and can uprev tune any customer's vehicle?

__________________
2010-PW-370z Fast Intentions CBE 18" res + HFC, K&N Typhoons Intakes(Gen 3 Stillen soon), 20mm H&R Front - 25mm H&R Back, Shine Auto(Sunline)

Cmike2780

Basically you take your car to the shop, have it tuned on the dyno, pay $600 and leave with an UpRev license for your car. You also have the option to have it re-tuned at a lower price since you already have the license should you install a new bolt-on on the car for example.

__________________

[09][MB][6-Spd MT][Touring][Stillen Gen III][K&N][Borla CBE][Evo-R]

b1adesofcha0s

So you would have to pay a little extra to get the cable and access to Cipher, correct? What if you just buy a used uprev cable from someone?

__________________
Project: b1adeZmobile (2009 370Z) | Uprev Tune by AAM Competition | Berk Exhaust
Project: b1adeZmobile 2.0 (2014 C7 Z51) | Corsa Xtreme Exhaust

Josh@STILLEN

$200 for the cable which also has a Cipher license.

Yes, you can purchase a used cable from someone, they are not married by VIN. You can also use the UpRev cable to trouble code check anything OBD-II (any newer vehicle).. as much as you want.

b1adesofcha0s

Thanks for the clarification!

__________________
Project: b1adeZmobile (2009 370Z) | Uprev Tune by AAM Competition | Berk Exhaust
Project: b1adeZmobile 2.0 (2014 C7 Z51) | Corsa Xtreme Exhaust

Compdoc777

This cable wouldn't be a Tatrix obd2 to USB would it?

Also how much gain all stock with a tune?

spdonegan

Should be getting my UpRev hardware (standard - may go to tuner later) so I'll see what cable it has. I have several other OBD-II cables (serial, USB and even a WiFi one).

Now to my question - 2011 370Z Coupe, AT, Stillen intake, Stillen exhaust, Stillen headers and Berk cats (both yet to be installed). So what RWHP should I expect. My math seems to say a bit north of 350 RWHP and I found one dyno sheet with everything but the headers that showed 338 RWHP - curious if anyone else has the same gear and results?

Happy Holidays!

prescott3656

Never seen anyone near 340whp with bolt-ons. Depends on the dyno, some read high, ideally, you get the dyno numbers before and after a mod and check the difference.

b1adesofcha0s

Depends on the dyno really. Some read high while other read low. Most people with similar mods seem to average around 300-320 whp depending on the dyno. Anything higher than around 320 or so is probably a high reading dyno. Like prescott said though, it's only the change in whp from the mods that really matters.

__________________
Project: b1adeZmobile (2009 370Z) | Uprev Tune by AAM Competition | Berk Exhaust
Project: b1adeZmobile 2.0 (2014 C7 Z51) | Corsa Xtreme Exhaust