UpRev ECU tune results for Semtex's Z

semtex · 10-30-2009, 02:19 PM

Okay folks, all is not well. Two things are going on.

First, since getting the tune done, my car is doing something rather strange on cold starts. I start the car, wait my normal 30 seconds for everything to warm up, and when I slip it into 1st and tip the throttle in, there's like this weird dead spot. Gas pedal goes down a little, I start to feather the clutch in (same thing I've done a million times before), and nothing. The rpms just kinda don't go up, then all of a sudden, WHAM, the rpms jump up to where they ought to be and I go lurching forward like I've never driven stick before. But it only happens on cold starts, and goes away as soon as the car has warmed up a little more. Like by the time I get out of my neighborhood and make it to the first set of lights a half-mile from my subdivision, the problem is gone. I can launch as smoothly as always. No dead spot, no lag effect.

The first time this happened was yesterday morning when I left to go to the gym. I thought maybe it was my imagination or maybe it was human error on my part. But this morning, it did the same thing. It even did it when I was done with my workout and left the gym to come back home (car sat for about 2 hours). Something is f'd up. The driveability of my car has been compromised.

Okay, the second thing going on is this. I just got back from my DynoJet pulls. I have LOST approx. 15whp since my last DynoJet pull on the same DynoJet! Check it out. RunFiles 003 and 005 below are from today. RunFile 010 is from back in May.

I know, I know . . . different pulls on different days, months apart, right? But look at the run conditions:

The green and yellow lines are from today. The blue one is from May. It was cooler today than it was in May. Humidity is higher today than in May, but the correction factors should compensate for that.

Take these two things together -- the weird dead spot on cold start, plus the bizarre dyno results, and I think I'm being fair in saying that something ain't right!

I haven't been able to talk to Sharif yet, so I'm not sure what the next steps are. But right now, I'm about ready to have him flash my stock tune back in. This is not the desired result.

NIZMOZ · 10-30-2009, 02:42 PM

330rwhp on a dynojet sounds way off. Like it was out of calibration. No way your car would do that. But the other numbers sound right compared to Forged dyno. That is normal. I think your car is fine.

Quote:

Originally Posted by semtex

Okay folks, all is not well. Two things are going on.

First, since getting the tune done, my car is doing something rather strange on cold starts. I start the car, wait my normal 30 seconds for everything to warm up, and when I slip it into 1st and tip the throttle in, there's like this weird dead spot. Gas pedal goes down a little, I start to feather the clutch in (same thing I've done a million times before), and nothing. The rpms just kinda don't go up, then all of a sudden, WHAM, the rpms jump up to where they ought to be and I go lurching forward like I've never driven stick before. But it only happens on cold starts, and goes away as soon as the car has warmed up a little more. Like by the time I get out of my neighborhood and make it to the first set of lights a half-mile from my subdivision, the problem is gone. I can launch as smoothly as always. No dead spot, no lag effect.

The first time this happened was yesterday morning when I left to go to the gym. I thought maybe it was my imagination or maybe it was human error on my part. But this morning, it did the same thing. It even did it when I was done with my workout and left the gym to come back home (car sat for about 2 hours). Something is f'd up. The driveability of my car has been compromised.

Okay, the second thing going on is this. I just got back from my DynoJet pulls. I have LOST approx. 15whp since my last DynoJet pull on the same DynoJet! Check it out. RunFiles 003 and 005 below are from today. RunFile 010 is from back in May.

I know, I know . . . different pulls on different days, months apart, right? But look at the run conditions:

The green and yellow lines are from today. The blue one is from May. It was cooler today than it was in May. Humidity is higher today than in May, but the correction factors should compensate for that.

Take these two things together -- the weird dead spot on cold start, plus the bizarre dyno results, and I think I'm being fair in saying that something ain't right!

I haven't been able to talk to Sharif yet, so I'm not sure what the next steps are. But right now, I'm about ready to have him flash my stock tune back in. This is not the desired result.

B1nks · 10-31-2009, 11:40 AM

Quote:

Originally Posted by semtex

Okay folks, all is not well. Two things are going on.

First, since getting the tune done, my car is doing something rather strange on cold starts. I start the car, wait my normal 30 seconds for everything to warm up, and when I slip it into 1st and tip the throttle in, there's like this weird dead spot. Gas pedal goes down a little, I start to feather the clutch in (same thing I've done a million times before), and nothing. The rpms just kinda don't go up, then all of a sudden, WHAM, the rpms jump up to where they ought to be and I go lurching forward like I've never driven stick before. But it only happens on cold starts, and goes away as soon as the car has warmed up a little more. Like by the time I get out of my neighborhood and make it to the first set of lights a half-mile from my subdivision, the problem is gone. I can launch as smoothly as always. No dead spot, no lag effect.

The first time this happened was yesterday morning when I left to go to the gym. I thought maybe it was my imagination or maybe it was human error on my part. But this morning, it did the same thing. It even did it when I was done with my workout and left the gym to come back home (car sat for about 2 hours). Something is f'd up. The driveability of my car has been compromised.

Okay, the second thing going on is this. I just got back from my DynoJet pulls. I have LOST approx. 15whp since my last DynoJet pull on the same DynoJet! Check it out. RunFiles 003 and 005 below are from today. RunFile 010 is from back in May.

I know, I know . . . different pulls on different days, months apart, right? But look at the run conditions:

The green and yellow lines are from today. The blue one is from May. It was cooler today than it was in May. Humidity is higher today than in May, but the correction factors should compensate for that.

Take these two things together -- the weird dead spot on cold start, plus the bizarre dyno results, and I think I'm being fair in saying that something ain't right!

I haven't been able to talk to Sharif yet, so I'm not sure what the next steps are. But right now, I'm about ready to have him flash my stock tune back in. This is not the desired result.

Ok well I haven't done a dyno pull on my original dyno but the same exact thing is happening with me as far as cold start drivability. I just had my done by uprev on Thurs. And I'm in Dallas right now and haven't contacted rich cause it's the weekend but I will be. Didn't drive my car again till last night and it did that along with this morning. A little upset but hopefully UpRev will make things right. I'm really curious about that horsepower loss, I have the opportunity to re-dyno my car on my original car possibly Monday but we'll see, might not have the funds.

John@Z1 · 10-31-2009, 01:04 PM

Quote:

Originally Posted by B1nks

Ok well I haven't done a dyno pull on my original dyno but the same exact thing is happening with me as far as cold start drivability. I just had my done by uprev on Thurs. And I'm in Dallas right now and haven't contacted rich cause it's the weekend but I will be. Didn't drive my car again till last night and it did that along with this morning. A little upset but hopefully UpRev will make things right.

We all know that Uprev will take care of the cold issue. But on Semtex's #10 dynojet run what the graph does at 4150rpm is kind of strange.

10-30-2009, 02:19 PM	#1 (permalink)
semtex A True Z Fanatic Join Date: Jan 2009 Location: Behind enemy lines Age: 55 Posts: 5,995 Drives: People to drink Rep Power: 34	Problems Okay folks, all is not well. Two things are going on. First, since getting the tune done, my car is doing something rather strange on cold starts. I start the car, wait my normal 30 seconds for everything to warm up, and when I slip it into 1st and tip the throttle in, there's like this weird dead spot. Gas pedal goes down a little, I start to feather the clutch in (same thing I've done a million times before), and nothing. The rpms just kinda don't go up, then all of a sudden, WHAM, the rpms jump up to where they ought to be and I go lurching forward like I've never driven stick before. But it only happens on cold starts, and goes away as soon as the car has warmed up a little more. Like by the time I get out of my neighborhood and make it to the first set of lights a half-mile from my subdivision, the problem is gone. I can launch as smoothly as always. No dead spot, no lag effect. The first time this happened was yesterday morning when I left to go to the gym. I thought maybe it was my imagination or maybe it was human error on my part. But this morning, it did the same thing. It even did it when I was done with my workout and left the gym to come back home (car sat for about 2 hours). Something is f'd up. The driveability of my car has been compromised. Okay, the second thing going on is this. I just got back from my DynoJet pulls. I have LOST approx. 15whp since my last DynoJet pull on the same DynoJet! Check it out. RunFiles 003 and 005 below are from today. RunFile 010 is from back in May. I know, I know . . . different pulls on different days, months apart, right? But look at the run conditions: The green and yellow lines are from today. The blue one is from May. It was cooler today than it was in May. Humidity is higher today than in May, but the correction factors should compensate for that. Take these two things together -- the weird dead spot on cold start, plus the bizarre dyno results, and I think I'm being fair in saying that something ain't right! I haven't been able to talk to Sharif yet, so I'm not sure what the next steps are. But right now, I'm about ready to have him flash my stock tune back in. This is not the desired result. __________________ "There are no small accidents on this circuit." -- Ayrton Senna 316.8whp & 248 ft/lbs (Dyno Dynamics) \| 319whp & 256 ft/lbs (DynoJet) (04/23/10) Stillen G3 CAI, CBE, Pulley / F.I. LTH / GTSpec Ladder Brace / Setrab Oil Cooler / UpRev-tuned by Forged Perf.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Semtex's Monterey Blue 370Z	semtex	Member's 370Z Gallery	235	06-21-2013 12:49 AM
Cobb vs UpRev	FricFrac	Tuning	183	11-05-2009 05:14 PM
UpRev still coming out for the 370Z	FricFrac	Tuning	2	08-22-2009 07:32 AM
UpRev development status	semtex	Tuning	12	07-13-2009 11:34 AM
Semtex, RCZ... What gear on the dyno	DannyGT	Engine & Drivetrain	14	04-14-2009 01:07 PM