[Official] Which 1st mod(s) for my Z thread.

[turbojoe370z]

Originally Posted by chuckd05

Well in NY if your Engine light is off, you're fine for inspection. 9 out of 10 times you car wont go up on the lift... There is also a ton of shops around so if you just be honest with them , you will find one to pass you. I guess it depends on how strict your state is though.

There are a drawbacks with the test pipes but should make a smidge more power than the hfc

very True NY really only cares about the check engine light and that all of the readiness codes are set (your allowed (1) not ready) they don't really bother with pulling the wheels off and putting on the lift (unless you get a shop looking to soak you for money)

[Kraken370]

My first mod was aam exhaust.

[shadow85]

So what would be the maximum power I can get from my 2015 370Z without going twin turbo or supercharged and what a the costs normally?

[Mancub]

Originally Posted by shadow85

So what would be the maximum power I can get from my 2015 370Z without going twin turbo or supercharged and what a the costs normally?

I think I've read that people can get over 400 at the crank, but no one has broken the 400 whp threshold. Cost = hella much.


Sent from my XT1254 using Tapatalk

[shadow85]

Originally Posted by Mancub

I think I've read that people can get over 400 at the crank, but no one has broken the 400 whp threshold. Cost = hella much.


Sent from my XT1254 using Tapatalk

I googled it and apparantly most if not all can only manage to get around 320 @ the wheels!?

[phil2986]

First mod Airlift Autopilot 3P kit, installed earlier today.

[ramoszx12r]

Originally Posted by phil2986

First mod Airlift Autopilot 3P kit, installed earlier today.

Looking good Phil hope to see it this summer.

[JckHmr]

Originally Posted by phil2986

First mod Airlift Autopilot 3P kit, installed earlier today.

Oh my god that is sexy. How would you rate the difficulty of installing air on the 370z on a 0-10 scale? Just this month I've helped two friends bag-over-coils on their Mazdaspeed 6's and it's a pain the *** with some welding required.