What did you do with your Z today IV

kenchan

good am everyone! TGIF!

mr.gale- took forever to logon this am for some reason. here is the pict of the e-tape sandwiched
in the arm/holder to prevent rattle on the satechi. i used red so it is easy to see. just tape the
holder clip area and side it into the arm. no more rattles. im going to make a tripod mount later
to work with the arm.



here is how i have it mounted. if you have a passenger chances are her elbow will hit the recorder, so i suggest you have
an alternate mount location just in case you want to take someone along. for me i would just use the real sony mic in such
case, or mount the recorder on the rear bar.

GaleForce

Good morning Mr.kenchan

Is it forum troubles that kept you from loggin in, or obligations at work?

Thanks for posting the pictures. I'm looking forward to getting things set-up. The pictures help.

The mount looks like a quality piece.

__________________

kenchan

hahaha, yah, both. i had a long day at work yesterday. but i was able to do some car stuff in the garage last night so that was

the satechi is probably one of the best ones out there...but that swivel that can't click to its horizontal detent is

btw, im not sure about the zoom you bought, but my tascam's mic polar pattern (mic's pickup pattern) is directly forward to 90degress perpendicular. so that means it will prioritize sound that is picked up forward of the front seats. since the cabin is small it picks up a lot of the nice exhaust note too while reducing road noise.

if i want more bass frequency of the exhaust i could position the recorder pointing more towards the ceiling, but will also add the rumbling road noise down 25-55hz area. i suggest not using any hi-pass filters or limiter on the recorder and just play with the positions first.

GaleForce

This is form the Zoom website,

"The H1's built-in directional microphones focus on the sound being recorded. Unlike omnidirectional microphones, which pick up sound all around indiscriminately, the H1 mics ignore the unwanted noise behind them."

So it sounds like it will record whatever is in front of the mic better than the rear. The nice thing about that cup holder mount is it will be easy to play around with positioning like you suggest.

After your experimenting, it really showed that the stand alone mic is the best option to achieve the best sond quality. I can also use it in a similar fashion with my 7D. If I can't get the desired sounds in the Z, I can always add an external mic for outside of the car.

__________________

kenchan

hahahaha, i see. i must listen to more top40's radio so i am with the times...

cool! it's good that it has directionality. yah, if the gopro has a quieter noise floor and if we were recording in a quiet environment the setup would be different, but for in-vehicle application (or any application where you can have the recorder away from the camera) this is so far the best i think.

the biggest differentiator is that you can also record the audio in your audio recorder and sync it later if needed. you can't do that with just an external mic on the gopro. it's you get wat you get (with no input level metering so who knows if you're clipping or not. it's like aiming the camera with no LCD! lol it's just too much guess work).

the next gen hero needs to have LCD, input level meter, and quieter noisefloor for sure.