|
if anyone takes one of these solenoids out of the, please check to see if there is any lubricant at all on the pin or opening. Condensation on metal that
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
02-11-2011, 05:20 PM
|
#27 (permalink) |
|
A True Z Fanatic
Join Date: Dec 2010
Location: Michigan
Posts: 6,365
Drives: 3500 NVP 370Z-sold!
Rep Power: 86625   |
if anyone takes one of these solenoids out of the, please check to see if there is any lubricant at all on the pin or opening. Condensation on metal that then freezes can be one possible scenario for the sticking pin. also, the programming on the BCM needs to be checked to make sure this voltage to disengage the pin does not stay applied until a feedback signal. There is no reason this solenoid needs more than 2 seconds of being energized to do the job. anymore, and the life expectancy is going to be diminished. has anyone experienced this twice?
If one wire becomes shorted to power or ground, this could cause the solenoid to prematurely die. I wonder if there is possibly a harness problem?
__________________
Get some roosters for eggs and Bulls for milk . Then you will see that gender matters. Especially at milking time. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pic request: 370z engine bay w/stillen g3's and Seibon engine cover. | atx370z | Nissan 370Z Photos / Spyshots / Video / Media Gallery | 20 | 01-05-2011 12:50 PM |
| My engine oil is low | TongMan | Nissan 370Z General Discussions | 14 | 07-17-2010 04:52 PM |
| 370Z Not Cranking Problem | Master_Ly | Nissan 370Z General Discussions | 38 | 05-06-2010 09:50 PM |
| Engine oil question | leepeen | Engine & Drivetrain | 18 | 12-02-2009 11:33 PM |
| G37 engine and 370z engine | kannibul | Nissan 370Z General Discussions | 21 | 08-12-2009 01:58 AM |
2Likes
Threaded Mode
