Shifting 1st to 2nd

Parrotguy · 06-09-2010, 01:20 PM

The earlier posts in this thread conclude that for the reasons stated, throttle float etc., the rpms do not drop quickly enough after releasing the clutch in first gear. That would mean the clunk is caused by the rpms being too high for the smooth transition to second. This is supported by those who say going from first to third works smoothly. Later posts say increase the rpms before shifting, which would seem to make the problem worse.

Because the car has 6 speeds, the gearing is close together, so the cars momentum together with the rpms not dropping quickly enough contributes to second being too low a gear for the car in that situation - third works better. Under hard acceleration the car "needs" second and the problem goes away. The car has so much power it doesn't "need" 6 gears for slow, in traffic, driving.

I think if you tried to drive a formula one car in heavy traffic, the same thing would happen ( if they had manual transmissions).

Maybe the first to third in slow traffic is the answer??

kenchan · 06-09-2010, 01:33 PM

Quote:

Originally Posted by Parrotguy

Maybe the first to third in slow traffic is the answer??

i dont skip gears.

Modshack · 06-09-2010, 04:20 PM

Quote:

Originally Posted by kenchan

i dont skip gears.

Yeah...I paid for all 6....I intend to use them!...

6MT · 06-10-2010, 12:15 PM

Quote:

Originally Posted by Modshack

Yeah...I paid for all 6....I intend to use them!...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rough shifting 7AT	rico magic	Engine & Drivetrain	10	07-08-2011 02:30 AM
Shifting Into First Not Possible...	Hugoneus	Nissan 370Z General Discussions	50	03-16-2010 06:36 PM
shifting without the clutch...	M1K3	Nissan 370Z General Discussions	29	02-22-2010 07:41 PM
Shifting from 5th to 6th.	gh0st3794	Engine & Drivetrain	1	02-19-2010 03:11 PM
MT Shifting Question(s)	Slynky	Engine & Drivetrain	30	02-10-2010 06:03 PM

06-09-2010, 01:20 PM	#1 (permalink)
Parrotguy Base Member Join Date: Oct 2009 Location: San Diego Posts: 51 Drives: '10 Roadster Touring Rep Power: 17	The earlier posts in this thread conclude that for the reasons stated, throttle float etc., the rpms do not drop quickly enough after releasing the clutch in first gear. That would mean the clunk is caused by the rpms being too high for the smooth transition to second. This is supported by those who say going from first to third works smoothly. Later posts say increase the rpms before shifting, which would seem to make the problem worse. Because the car has 6 speeds, the gearing is close together, so the cars momentum together with the rpms not dropping quickly enough contributes to second being too low a gear for the car in that situation - third works better. Under hard acceleration the car "needs" second and the problem goes away. The car has so much power it doesn't "need" 6 gears for slow, in traffic, driving. I think if you tried to drive a formula one car in heavy traffic, the same thing would happen ( if they had manual transmissions). Maybe the first to third in slow traffic is the answer??