![]() |
You will need another person and to jack the car up and place it on jackstands. Lift it high enough to be able to drill pilot holes from under the
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#11 (permalink) |
A True Z Fanatic
![]() Join Date: Aug 2010
Location: WNY
Posts: 4,117
Drives: 12 ZL1 6mt black
Rep Power: 43 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
You will need another person and to jack the car up and place it on jackstands. Lift it high enough to be able to drill pilot holes from under the side blades. Also you need to have somebody hold the side blades up while you eye from above to make sure they are even wth the door when looking from above. Make sure you use your hands to check that the blades are correct front to back. Do not try to view if they are correct with the wheel wells as they can look off but are correct to the wheel well. Hard to explain but it is very hard to align by site front to back. Drill pilot holes and peel tape as you go. Easiest if you put a screw at the front then back and work towards the middle. Good luck as I said I was able to do it so anybody should LOL
![]()
__________________
2012 Chevy Camaro ZL1 6MT coupe Back N' Black. 680hp ![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Got Z? I did today! | dharvison | New 370Z Owner | 17 | 12-14-2011 04:45 PM |
Saw a GTR today | bigaudiofanat | The Lounge (Off Topic) | 30 | 07-15-2011 05:14 PM |
Today was the day! | NewYorkJon34 | New 370Z Owner | 4 | 06-23-2009 03:03 PM |
Just got it Today 6/14/09 :D!!!! | COD4 | New 370Z Owner | 15 | 06-21-2009 04:22 PM |
New as of today | prodigyz | New 370Z Owner | 1 | 04-14-2009 12:42 AM |