YzGyz

The kit install itself is not bad at all. I would estimate it would take good weekend (25 hrs) If you have all your tools lined up. I approve of the kit's design. The instructions for the most part is clear. There were some areas that I couldn't follow but you could post and ask for help. Quite a few people have taken on the task so there are people who can help. SASHA is pretty good with respond to e mails And pm's. I would rate the turbo install itself a 6/10.

List of things to have ready:
-clutch and flywheel to handle power goal
-tools, sockets, lots of extensions, wobble bits, large adjustable Cresent wrench
-safe flat surface and Jack stands
-some lube ( I used water based like KY) to lube up the couplers so they slide together easier
-good light to see around in
-make sure you can get the cat off
-soldering iron and shrink wrap

Hey YzGyz! I was just looking at your build thread and I was wondering how the installation of your BP turbo was and any initial thoughts or comments on the setup in general?

Pins are out of my toes. :D No more toe-kabobs!:icon17: Have to wear a toe brace and a walking boot for another 2 weeks or so. Foot is still sore under the front pad. Think they sprained my ankle...

What routine do you guys do on cleaning the exhaust tip. I tried cleaning it with car soap and a rag but I couldn't get the stain out.

Thanks for sharing this Pauly Z. For everyone else? Please.... https://metrouk2.files.wordpress.com/2014/11/let-it-go.gif

PaulyZ If you can't handle answering a few questions for clarification, take yourself back to my350z.com or whatever place you came from. You went 'full retard' in your responses, instead of...

Front is on, will be getting some better pictures here shortly, my camera phone skills aren't doing it any justice. https://farm6.staticflickr.com/5698/23912183636_26a3c75c92_b.jpg ...

Started trying to trouble shoot it yesterday. Moved the amp and cables by the amp around it it fixed the problem. Left door speaker sounds a little weaker and doesn't hit as hard as the right but I...

Hell no! Way too much ground to cover. And then you still do the troubleshooting anyways.

http://i1159.photobucket.com/albums/p635/tcalvin04/Mobile%20Uploads/IMG_20160303_085150_zpsjxu5vg6h.jpg...

Yesterday I noticed that the upper most part of my center console near the shifter was scratched to all heck. Most likely due to the zipper on my jacket. It's been frío in NE Florida lately. ...

please don't do this to your Z.

Cant say whether or not adding the second cable would have an impact on your subwoofer, but adding the cable from sub out to amp will certainly give you more control over the sub... I know I would...

The reason for this is that you would have lower IM pressure. There is always a pressure drop across the system (piping and intercooler), and by taking the lines to the compressor cover, (for...

the perfect spot for a square boost controller, sits a good amount "inward" in case of wandering hands Btw - The GFB is super easy to use and understand. ...

OP, when you take it apart give us a DIY. I need to change my cluster out and I have no idea how

A couple of people have ask me to post my set-up. So here it is. :D Forgeline Wheels, ZX3R Front: 19x9.5, +25, Mich PSS 275/35-19 Rear: 19x12, +28, Mich PSS 305/30-19 Alignment Spec's:...