thangcu35

Did you ever get around to making a DIY thread or video on your Typhoon -> CAI conversion? I just came across your thread and I would love to do this myself but I'm wondering if and where I could find more detailed information, thanks.

Had a new pair of Nitto INVO to replace the worn Michelin PSS and got an alignment. Took the chance to snap a pic under the car while it was up on the lift. This shows how I braced the turbos to the...

If you're impressed by a Civic's exhaust, I'm pretty sure ANY 370z exhaust on the market right now will exceed your expectations. ;)

If you're impressed by a Civic's exhaust, I'm pretty sure ANY 370z exhaust on the market right now will exceed your expectations. ;)

I had the chance to re-tune the flex fuel sensor of my friend's built G35 Greddy TT kit on E85 and E10 (pump 93). I love working with Haltech EMS, much more user friendly than other standalone EMS...

I had the chance to re-tune the flex fuel sensor of my friend's built G35 Greddy TT kit on E85 and E10 (pump 93). I love working with Haltech EMS, much more user friendly than other standalone EMS...

I had the chance to re-tune the flex fuel sensor of my friend's built G35 Greddy TT kit on E85 and E10 (pump 93). I love working with Haltech EMS, much more user friendly than other standalone EMS...

I had the chance to re-tune the flex fuel sensor of my friend's built G35 Greddy TT kit on E85 and E10 (pump 93). I love working with Haltech EMS, much more user friendly than other standalone EMS...

I had the chance to re-tune the flex fuel sensor of my friend's built G35 Greddy TT kit on E85 and E10 (pump 93). I love working with Haltech EMS, much more user friendly than other standalone EMS...

I MAY have considered going BP's single turbo setup but with Comp's oil-less turbo. I didn't want to drop the motor or transmission to install the turbos and relocate wires and hoses, and I can't...

Not bad. I'm sure it will perform better than oem but those ripples in the tubes are not going to help with flow. What i did with my typhoon intake was flipped it around and run 3" piping to the...

Not bad. I'm sure it will perform better than oem but those ripples in the tubes are not going to help with flow. What i did with my typhoon intake was flipped it around and run 3" piping to the...

Usually with upgraded pressure plate, there will be increased load/wear on the thrust washers in the crankshaft during the initial crank/start up because there is little oil to lubricate the washers...

Used for approx 5-7k miles. Sold

Here it is dyno tuned. 472whp & 421ft-lb @9psi The combination of cold weather and worn out Michelin PSS gave me a hard time with traction on the rollers. 4th gear would not hook. I ended up...

Here it is dyno tuned. 472whp & 421ft-lb @9psi The combination of cold weather and worn out Michelin PSS gave me a hard time with traction on the rollers. 4th gear would not hook. I ended up...