Nissan 370Z Forum

370Z Forums HOME

My Picture Album

Nissan 370Z Pictures

Premium Membership

Become a Forum Sponsor

		Nissan 370Z Forum > Members List
SwedeZ's Profile

SwedeZ is on a distinguished road

SwedeZ

Base Member

Last Activity: 03-18-2023 02:59 PM

About Me

About SwedeZ

Location

Sweden

Drives

2013 370z MT
Signature
Top Gun Rotrex ¤ Wiseco pistons ¤ K1 rods ¤ ARP bolts/studs ¤ Cometic head gasket ¤ ID 1050 ¤ Walbro 450 ¤ CJM S1.E ¤ Custom return fuel system ¤ Boundary oil pump ¤ Xforce exhaust ¤ Xtreme twin plate clutch ¤ 25 row oil cooler ¤ EcuTek

Statistics

Total Posts

Total Posts: 35
Posts Per Day: 0.02
Find all posts by SwedeZ
Find all threads started by SwedeZ

General Information

Last Activity: 03-18-2023 02:59 PM
Join Date: 05-09-2020
Referrals: 0

Likes Given

369 Likes

SwedeZ liked post by TopgunZ On thread : Announcing TopgunZ ACE Supercharger Kit!

Introducing the TopgunZ ACE kit! We all know how much of an improvement my original Air to Air kit released in 2015 was over the Water to Air on the Stillen kit. The extra power it could handle...
Liked On: 07-24-2020, 07:21 AM
Posted On: 11-13-2019, 07:58 AM
SwedeZ liked post by 13Xterra On thread : ATTENTION: ALL Nismo 370Z Owners: Please check your suspension!

This is bizarre. In my introduction to the forum post a few days ago, I mentioned how I wasn’t going to mod my car all that much because I was more into detailing and paint correction. However, the...
Liked On: 07-24-2020, 06:50 AM
Posted On: 06-26-2017, 08:52 PM
SwedeZ liked post by HIZZY On thread : ATTENTION: ALL Nismo 370Z Owners: Please check your suspension!

I luckily had some good guys at my dealership & very professional. They showed me the vehicle delivery report and checklist RIGHT AT THE TOP IT SAYS "REMOVE NISMO SPRING SPACERS" it's like...
Liked On: 07-24-2020, 06:47 AM
Posted On: 04-14-2017, 01:19 PM
SwedeZ liked post by BehindSpace On thread : ATTENTION: ALL Nismo 370Z Owners: Please check your suspension!

you expect too much from dealership workers and technicians. 99% are not car enthusiasts and are just trying to get through the day to get paid at a 9-5 job they are most probably miserable being...
Liked On: 07-24-2020, 06:46 AM
Posted On: 10-30-2016, 06:08 PM
SwedeZ liked post by JLarson On thread : Z from Europe

Was that part of the allure of owning one? The relative rarity? I haven't made it to Sweden yet. I was planning to visit Norway again this year (my brother lives there with his wife and my niece)...
Liked On: 06-10-2020, 04:06 AM
Posted On: 06-09-2020, 07:52 AM
SwedeZ liked post by Dentt42 On thread : Sticky: (Official) 370Z Clutch Pressure (CSC) Failures

I just went through almost the exact same ordeal when my CSC went out unexpectedly, and yeah, it's a monetary doozie if you haven't planned for it. Not including the CMAK I was lucky enough to...
Liked On: 06-01-2020, 05:06 AM
Posted On: 05-22-2020, 09:00 AM
SwedeZ liked post by babyzilla On thread : Sticky: (Official) 370Z Clutch Pressure (CSC) Failures

Just got off the phone with Joe from Zspeed. Just as everyone said, he was very helpful. Rather than replacing the slave cylinder, I went with Joe's recommendation and I will be replacing the entire...
Liked On: 06-01-2020, 05:04 AM
Posted On: 05-21-2020, 10:49 AM
SwedeZ liked post by ZontheRocks On thread : Sticky: (Official) 370Z Clutch Pressure (CSC) Failures

Consensus is to eliminate with the CMAK.
Liked On: 06-01-2020, 01:42 AM
Posted On: 02-04-2020, 06:09 AM
SwedeZ liked post by Joe@ZSpeed On thread : Clutch & Flywheel advice please

I have the 2018+ clutch sitting here, A WHOPPING 1700lb clamp load with a 240mm disk, This is pretty weak... Even our stage one kit has 2,000lbs of clamp load and a 250mm disk. And they are...
Liked On: 06-01-2020, 01:29 AM
Posted On: 09-20-2017, 10:38 AM
SwedeZ liked post by JARblue On thread : Clutch & Flywheel advice please

I call :bs: They didn't change the shitty design of the CSC. I don't believe a softer pressure plate is going to change jack. That rubber lining is not going stand up. I'll believe it when I...
Liked On: 06-01-2020, 01:29 AM
Posted On: 09-20-2017, 08:08 AM
SwedeZ liked post by OKC Z On thread : South Bend Clutch-bad install

I finally got my car in the Nissan shop to get the ECM replaced and while it was there I had them do a complete clutch flush. They called it brake flush. I told them I had the clutch replaced and...
Liked On: 06-01-2020, 12:41 AM
Posted On: 05-03-2012, 05:47 AM
SwedeZ liked post by Joe@ZSpeed On thread : South Bend Clutch-bad install

I found that the air is trapped at the master and believe this has been the issue for some of the guys in the 370Z, The HR 350'z don't seem to have much trouble bleeding the systems nor have I in...
Liked On: 06-01-2020, 12:39 AM
Posted On: 02-16-2012, 06:57 PM
SwedeZ liked post by Joe@ZSpeed On thread : South Bend Clutch-bad install

There are no problems with this set-up, It is simply a bad install or it is incorrectly adjusted. The high pedal engagement happens on the HR and VHR's with an aftermarket clutch. We are working...
Liked On: 06-01-2020, 12:31 AM
Posted On: 02-11-2012, 06:11 PM
SwedeZ liked post by Business Kat On thread : South Bend clutch review

Short version is that it's awesome and a lot better than the stock clutch. I don't remember much about the stock clutch other than it was better than the my 2012 camaro special lemon edition I...
Liked On: 05-31-2020, 11:53 PM
Posted On: 02-21-2015, 08:34 PM
SwedeZ liked post by Kzonts On thread : Opinions needed:ZSpeed HD CSC or Z1 Motorsports Slave Delete

I chose to be proactive and not wait. This way you can drive with confidence and plan those spirited driving trips without worry. I didn't want to deal with all the BS of a failure and it happening...
Liked On: 05-31-2020, 11:15 PM
Posted On: 12-07-2017, 07:08 AM

Page 23 of 25

23

Mini Statistics

Age: 47
Join Date: 05-09-2020
Total Posts: 35
Likes Received: 21
Likes Given: 369

Show All Statistics

Recent Visitors

The last 6 visitor(s) to this page were:

This page has had 1,386 visits

All times are GMT -5. The time now is 04:21 PM.