gomer_110

Do you have any suggestions for spring rates? I am running motion control non-remote 2 ways with 12kg front and 10kg rear(stock location). Feels really soft to me and i get a lot of body movement. Rear seems pretty loose as well, i removed my rear sway and have 1/16th toe total. I plan on upgrading to the new tomei 1.5 lsd. In my current setup i overpower the sports oem lsd all the time on tight corners.

Thanks again.
Ryan

Having a hell of a time finding suspension settings to run the nismo 19x10.5 et23 wheels with 285 tires square. I found stuff of people using the rims but with smaller tires and no camber angles listed. I plan on running this setup in autox for stu class. Thanks

What was the cost of parts and install for clutch, CSC and flywheel upgrade, if you don't mind me asking?

Hi I have seen ya putting ur sway bars from eibach . And my question is "Are the nismo sway bars not good enough or you are looking at the better handling with eibach?" I think u did front and rear right. I went to a track race a couple weeks ago(my first time). wat happened to me was my nismo was stripping because I was on high speed then brake to make a hard corner. My rear wheels spin twice and I think it's partly cause of my sway bars. I am here to learn so your information would be super helpful. Thanks

Hi, just wanted to say hi. I'm in BG, if you're ever in the area hit me up or if there are any events in Toledo to gather. Thanks.

But they are Fast Intention straight pipes. Not local muffler shop straight pipes. There is a difference despite the simplicity :twocents:

the quote of mine that you're referring to (in a bit of a douche way fyi) was said PRIOR to the OP saying it's not about money. I said what I said based on precedent. typically 90% of the people...

narthex

Rpms

Question punk, how many Rams do you think these gears can withstand with the proper supporting mods?

this reminds me of the people who buy a Z then complain about paying for 93 in the tank. don't buy the car if you can't afford the maintenance and go for ebay mods :facepalm:

Stop being cheap, and save up for an exhaust. This isn't a civic. Just be happy with what you have

Those tires are wearing fine !! Turn faster, that'll fix your wear issue :rofl2:

The entire cupholder and three switches pop out of the center console as one piece. Easiest way is to stick your hand/fist inside the cupholder and pull it straight up and out. Then you can remove...

I had my clutch, lightweight flywheel, CSC and master cylinder replaced at ZSpeedPerformance and it was less than the $1952 that your dealer quoted you. Not to mention that the install was quick and...

I'll guarantee the pan to hold up to 9000rpm no problem... But I can't promise it will hold up to the other bits of engine that will be thrown through it when you get there :D

Buy a Ferrari, or a Porch, not a poor man's Porch, and they'll be symmetrical, lol

Are we going to start dragging out all the dirty laundry again! Lets just get some testing done and be done

So maybe you could contact Sam from gtm and have 1slow370z prototype fitted to a car to test your manifold on a well suited na Z? This is what a community does.

Autozone does it for you for FREE! Go and have it checked.