Elmo370z

Great buying experience on trader!!

Buying the BMW ABS unit that you suggested. Great solution at a fraction of the cost of a full Bosch racing ABS! I spoke to a race team running a 370Z who has it. They say it solved all the braking issues that haunt the stock 370z system. Thanks again for turning me on to it.

I’ll be at Sebring this weekend. Are you going?

Sorry, no shipping. The box weighs around 80 pounds

No prob; glad you're enjoying it!

I would like to know how it goes for you as well!

Where at. How much did it run you?

No, I had the shop do it and it's a bitch to do.

Yes I am.

Clean your mail box or get a prem. subsciption

That's pretty much where it was before.. To be honest I'm just ready to have my car back and I'm sure it will be fun as hell to drive.... :happydance: Hoping this time around we can get to 800whp...

excellent work! and a very fair dyno of the product with untouched vvel maps. if vvel is optimized below the point when they start gaining in this dyno you will see those kind of gains all the way...

I daily drove XP10/8's for a year. I sanded the rotors down on the rear as I didn't replace them. They did fine. They were great pads around town, especially when you get to play the game of how...

You don't get that with the factory VLSD. It is terrible. I was spinning one tire coming out of the turns on the dragon when I got on the throttle hard. That was stock NA. That is how bad the factory...

:icon18:

My understanding is that changing pad compounds (i.e. ceramic to metallic) on the same rotors requires reconditioning of the rotor surface. I've heard some guys just scuff it up with sandpaper,...

No ice mode here running xp12/xp10 on RS-3's but after reading Dorans possible issue with the pads not releasing and understreer as a result might be my issue! My cars got horrible understeer and...

Nissan was practically bankrupt in 99 then Renault swooped in to save it.

Finally dyno sheets 115442

If you have a return fuel system on your turbo car, usually fuel pressure will not hold more than a few seconds after the pump is off. Aftermarket regulators are not designed to hold pressure. To...

the top plates should be back from anodizing this week. the custom fittings are in production and I hope to have them in towards the end of the week. Once they come in I could begin shipping for...

Elmo, You won't have to wait long we have a customer car which just had this installed last week. And we are waiting on a new main harness before we put it on the dyno.

There was A post about this before, Hack Job is an understatement!!!

:iagree: Be afraid. Be very afraid.

Um I HOPE you have other mods to the SC, like a front mount intercooler( Topgunz kit), and tune with the speed density :/ or very least the Frozenboost heat exchanger and upgrade pump, If you still...