DR_

Wow that is impressive! Very nice, and shows where I need to work to pick up speed as well as getting my line & braking more consistent. Now the thing is I want to get back out now and not to wait for 6 mos! Thanks again.

Hi David. Do you have a kml file from HLT for MSR 3.1 that you could share with me? This is Google Earth map for one or more laps overlayed with corner & straight speeds and lateral Gs. I'm trying to figure out where I'm leaving too much meat on the bone besides the obvious (Ricochet & Big Bend).

Thanks,
Larry

Did you figure out what was causing the NST Crank Pulley failure?

It was the first ever public track event at the new track. It was hosted by The Drivers Edge, who I often instruct for, and it went really well. We hope we left them with a good impression as we...

Are you sure it wasn't a repo?

Here are some videos from last weekend's event. here I had a passenger that had never been on track before. I really thought he was going to barf. fcBTr_479mE my fastest lap of the weekend...

It was the first ever public track event at the new track. It was hosted by The Drivers Edge, who I often instruct for, and it went really well. We hope we left them with a good impression as we...

You don't get just the bolt, you get a whole new endlink. The rear endlink is a know failure point with larger swaybars. You might be able to get a lightly used endlink on the forum here for cheap as...

Your car doesn't know any difference if you put spacers on the car or if you put lower offset wheels on the car. They both do the same thing, push the wheel out. Just get a good brand, like H&R,...

Your car doesn't know any difference if you put spacers on the car or if you put lower offset wheels on the car. They both do the same thing, push the wheel out. Just get a good brand, like H&R,...

If you have thinner rotors then the pistons in the calipers will have to extend further to push the pads into the rotors. This will make the pedal feel soft.

Camber adjustment on the top of the coilover, often called camber plates, is for strut design suspensions. We have double wishbone front and multilink rear, not struts.

I have a click and I thought it was an axle. However after jacking up the car and rotating a wheel it sounded more like the hub. I then took off the wheel and the rotor and rotated the hub and there...

I have a click and I thought it was an axle. However after jacking up the car and rotating a wheel it sounded more like the hub. I then took off the wheel and the rotor and rotated the hub and there...

I just jack up each side and slide the ramps under the tires.

Well at least you know you've added 26.75 lbs. of downforce :)

If the core oil cooler isn't a Earls, Setrab, or Mocal it's likely Chinese made. Some of the Chinese oil coolers are pretty poor quality.

Looking good! I have an instructing gig there with Lone Star BMW March 21st-23rd. I can't wait to get back out there with the surge tank since last year I would start to starve on 16-17-18 after 5...