Mitco39's Build

GaleForce

I started running the O2 wires like you did but I ended up running the wires up and over the transmission with the waste gate hoses and then in the driver side firewall.

There is room to install things everywhere. I mounted the module for my EVC-s on top of the radio, the module for the Defi gauges between the radio and heater core. Once you pull the glove box you'll see some room. Also behind the passenger side kick panel, and under the passenger seat... You shouldn't have a problem hiding things.

__________________

Mitco39

I thought about going to the DS instead as well I just figured this way I have everything coming in on the one side. I think when I pull the trans to do the clutch I will just zip tie it further up under the firewall and this should work just fine. Right now its not touching any exhaust piping so it should be ok.

And I figured as much, one of the 3 gauges is on back order so I think I will wait to tear apart the dash until I atleast know it is on its way. I Dont want to forget where everything goes, haha. I started putting on the rear springs and working the roll bars last night. This will keep me busy most of today I would assume.

I need to go out and buy a heater for the garage (its about 5 degrees in there) to install the matting. GT said I need it to be atleast room temperature to have any luck getting it where I want it.

__________________
2007 Chevy Duramax - EFILive Tuned By Me
2010 40th W/ Nav - Boosted Performance - UpRev Tuned By Me
The Mrs. Ride -2012 335XI N55 BMW - Cobb Tuned By Me, Built by her
My Build --> http://www.the370z.com/members-370z-...39s-build.html