wstar's Journal

Originally Posted by wstar

Yeah I did my cutting at the front as well, way easier. Did you route as their pics show (i.e. the final tie on the lower suspension around way out to the back)? That was what caused the most problems for me. There didn't seem to be any way to tie down out there and have both enough slack for the stretch direction, and not have it crumple up right into the side of the tire in the opposite lock direction. Your tires aren't that much skinnier than mine, either. Did you check the "short" steering direction not rubbing?

Originally Posted by wstar

Yeah I don't get this at all. On the passenger side, I could've done a tight fit with just Stillen's recommendation (removing that small plastic square) and doing some extra bends. But on the driver's side, even when you remove the little plastic square in the wheel well, that only solves half the problem. There was no other hole on the other side (more towards the bumper) to reach that area in the first place, without cutting the vertical plastic piece that has the little built in round hole in it. Did you just force the hose to work with that hole? Seemed small for it to me, but it was moot since I have cooler lines running through there already, and both certainly can't fit.