TravisJB Journal

ChrisSlicks · 02-15-2012, 06:37 AM

Quote:

Originally Posted by travisjb

Wiring gurus (do we have any?)-

I'm putting an LED lighting system on my truck bed and running power through a relay and switch mounted in the cab... I noticed that when I turn power on to the lights I get a voltage spike on the low current 12v that includes a toggle switch. This is the same 12v that sends a remote on signal to my stereo amp (the blue wire)... it causes a loud crackle over the speakers, which I'm guessing is a voltage spike to the amp. In any event, I read that you can fix this by wiring in a diode across the relay control (85/86 terminals)... I bought a bunch of 1amp and 3amp diodes. How do I install those? There is a red end and a white end on the diodes, which goes to which terminal on the relay? Help a brother out! thanks

So your using the low current 12V signal to energize the relay via the switch? If that is the case then yes, the diode might help, but if the diode is just electrically noisy then it may not be a cure all. You could use unregulated battery voltage to feed the relay instead.

The white stripe on the diode indicates the cathode end (negative), I've never heard of a red stripe but they just might be trying to be helpful to mark the other end as positive. Wire the diode following the existing polarity.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DannyGT's Journal/Progress	DannyGT	Member's 370Z Gallery	174	10-17-2017 10:25 AM
RCZ's 370Z Journal.	RCZ	Member's 370Z Gallery	1743	08-09-2013 11:55 PM
Edmonton Journal Review of the 370Z	BanningZ	Nissan 370Z General Discussions	13	08-09-2009 05:44 PM