[MAZOC] Official "Off-Topic" Discussion Thread

[RandyD]

I am not seeing anything like these two parts - the little step on the rear fender (presumably to get into the rumble seat) and the round tube shape on the front bumper.

take it back - on that last one Jon posted i see a little rear step..

[4r3s]

Originally Posted by RandyD

I am not seeing anything like these two parts - the little step on the rear fender (presumably to get into the rumble seat) and the round tube shape on the front bumper.

take it back - on that last one Jon posted i see a little rear step..

I've been trying to key off the stamping on the engine bay where the breather fins are at. I have yet to spot one similar to the one in this pic so far. On your Grandma's the fins come all the way out to the end of the stamp. On all the pics we've seen so far trying to match with the fins stop a good 6-8 inches before the edge of the stamp.

The reason I'm using the stamping is because pretty much everything else could be aftermarket while the stamped metal would be tough to (not impossible just more difficult) to recreate. Something like a step to get in and out of the car or the bumper could have easily been swapped.