|
Originally Posted by kenchan hey there, haboob! can you post up a pict of your exhaust? my recommendation is not to 'bend' the hanger, but lower the entire bracket which
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
04-21-2013, 09:58 PM
|
#10 (permalink) | ||
|
A True Z Fanatic
Join Date: Aug 2012
Location: Surface of the sun.
Posts: 13,159
Drives: '18 GTI Autobahn DSG
Rep Power: 1387   |
Quote:
( Click to show/hide )
I think bending the hanger is all that I can do? I took a photo of the hanger yesterday too:
( Click to show/hide )
It's not a height issue, it just sticks out farther than the other (which is flush). I think bending the hanger is the only option.  Quote:
Last edited by Haboob; 04-21-2013 at 10:03 PM. |
||
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The New "What did you do with your Z today" (with off topic replies) IV | happytheman | The Lounge (Off Topic) | 10020 | 04-09-2013 11:47 AM |
| The New "What did you do with your Z today" (with off topic replies) III | happytheman | The Lounge (Off Topic) | 9956 | 02-10-2013 02:13 PM |
| The New "What did you do with your Z today" (with off topic replies) II | happytheman | The Lounge (Off Topic) | 10004 | 12-24-2012 07:31 PM |
| The New "What did you do with your Z today" (with off topic replies) | happytheman | The Lounge (Off Topic) | 10265 | 10-31-2012 11:15 PM |
| We learned a valuable lesson about the "VDC OFF" button today thanks to b1ades | birdmanx1 | Mid-Atlantic Region | 167 | 09-01-2011 09:50 AM |
6715Likes
can you post up a pict of your exhaust? my recommendation is not to 'bend' the hanger, but lower the entire bracket which is part of the hanger. my fujimura had similar issues where one side was higher than the other, so i just adjusted it by using a couple of washers to lower the entire bracket on one side. 
now sits perfectly even.
Threaded Mode
