ARK Muffler Cans really uneven!

ZedSled

Here are a couple of pics from the rear view with a tape measure illustrating the difference in muffler height. When these pics were taken my car was on the ground and sitting level. Alex states that the mid pipes are the problem and is supposed to be sending me a new set end of month.

However, I cant help but notice the difference in the bends of the muffler pipe section between the end of the mid pipe and the beginning of the muffler.

Attached Images

	ARK GRIP CBE_drivers.jpg (387.0 KB, 86 views)
	ARK GRIP CBE_passenger.jpg (398.3 KB, 88 views)

Glokwork

Wow thats a lot worse than I expected it to be. So is it more of a defective batch or perhaps mid pipes from a different application?

JC671

I had the same problem but it just needed to be re-aligned. I love the exhaust, sound and looks but its still a bit low. Only way I'd change it though if it was completely damaged.

__________________

A special "Thank You" to the Fast Intentions Crew!
"Fueled By Passion"

ZedSled

Ive tried re-aligning the CBE every way possible and actually have the passenger side muffler adjusted as high as it can go but its still way off. I do love the look and sound of the exhaust but I just wish it would fit correctly.

ZedSled

Wish I knew Glokwork, but apparently I am not the only person with this problem. Since starting this post there are a few others who recently purchased this CBE and are having the same problem. My only guess is that its a defective batch.