Problems installing Stillen CBE

daisuke149 · 12-06-2010, 12:03 PM

if your picture is about the part that is not fitting
thats not an issue
just gotta hold it up while you slike the other ppipe through
when you use the hangaers it will be between those two. shouldnt rattle. at all times that you tighten the bolts in each section, hold the part slightly up to keep it as "straight" as possible while tightening it.

Luna · 12-06-2010, 06:21 PM

Quote:

Originally Posted by daisuke149

if your picture is about the part that is not fitting
thats not an issue
just gotta hold it up while you slike the other ppipe through
when you use the hangaers it will be between those two. shouldnt rattle. at all times that you tighten the bolts in each section, hold the part slightly up to keep it as "straight" as possible while tightening it.

We tried sliding that pipe piece, but did not work unless the metal plate was either cut or removed. I bought the CBE with welds already done to stop any leaks. I'm not sure if that made a difference. For now, I removed the plate but I'm probably going to have to cut the center piece to make room for the pipe and still have my gas tank with some protection. FML, other than that the CBE sounds F**ing awesome!!

laricb · 12-17-2010, 08:14 PM

I installed my stillen CBE tonight and had no issues

Luna · 12-19-2010, 12:02 PM

Quote:

Originally Posted by laricb

I installed my stillen CBE tonight and had no issues

Awesome! I bought the older version of the Stillen CBE and it has fitment issues. Newer versions have done away with that issue and fit perfectly. Anyhow, enjoy!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stillen CBE Clearance Problems Fixed?	spearfish25	STILLEN	49	12-08-2010 08:32 PM
stillen g3 intakes? problems?	soshiro17	Intake/Exhaust	13	03-20-2010 05:44 PM
Got around to installing my G2s	M.J.	Wheels & Tires	16	01-26-2010 10:48 PM
How much for installing?	Valentino	Engine & Drivetrain	8	09-03-2009 07:37 AM
Installing a Kenwood	YellowStrider	Audio & Video	5	08-14-2009 03:44 PM

12-06-2010, 12:03 PM	#1 (permalink)
daisuke149 My *** is famous! Join Date: Mar 2010 Location: Alpharetta, GA Posts: 4,849 Drives: 2013 Boss 302 PW Rep Power: 33	if your picture is about the part that is not fitting thats not an issue just gotta hold it up while you slike the other ppipe through when you use the hangaers it will be between those two. shouldnt rattle. at all times that you tighten the bolts in each section, hold the part slightly up to keep it as "straight" as possible while tightening it.

12-17-2010, 08:14 PM	#3 (permalink)
laricb Base Member Join Date: Nov 2010 Location: NYC Posts: 32 Drives: NISSAN 370Z 40TH AN Rep Power: 16	I installed my stillen CBE tonight and had no issues