Berk Test Pipe install...*^$#ing factory bolts!!!

Trips · 01-30-2011, 10:49 AM

Quote:

Originally Posted by NISMOFO

Question. The bottom of the stocks cats where they bolt to the y-pipe should have three bolts/nuts per side right? My drivers side has two out of three nuts there. The bottom nut is missing. But there doesn't seem to be a lot of threads showing to even put a nut in there.

I bought my car used from a forum member that out the stock exhaust back on. Just wondering if I should have three nuts per side on the bottom part....that's how it is on the 350z.

Yes, each side has three bolts. I figure that over time since you bought it the bolt came loose and might of just fallen off? I would check to see if it has a small exhaust leak, and if it does? Replace the gasket and replace the missing bolt. You can find them at your local auto parts store or a local muffler shop.

NISMOFO · 01-30-2011, 01:25 PM

Quote:

Originally Posted by Triple's

Yes, each side has three bolts. I figure that over time since you bought it the bolt came loose and might of just fallen off? I would check to see if it has a small exhaust leak, and if it does? Replace the gasket and replace the missing bolt. You can find them at your local auto parts store or a local muffler shop.

I have an extra 350z nut that fits. But it looks like the cat isn't lined up with the header properly and the bolt is çrooked. If I put a nut on the bolt I think it starts to strip the threads. I think I do have an exhaust leak at high rpms maybe. Not sure if I should mess with or replace the stocks cats completel...lol. ill post a pic.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Which HFC or test pipe is the best??	holmanyu	Intake/Exhaust	3	07-19-2010 08:12 AM
Berk Exhaust Production with X-Pipe	Minicobra1	Intake/Exhaust	382	05-24-2010 10:30 PM
Installed Berk Test pipe	>135I	Exterior & Interior	13	09-11-2009 09:04 PM
Berk HFC or Berk Test Pipes?	bobby8621	Intake/Exhaust	16	06-24-2009 05:48 PM