|
I had a different code (PO300 error (cylinder misfire)), but the issue was the same. My idle wouldn't drop below 1.2k. If you just installed the intake, I'd say give
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-30-2010, 12:02 PM
|
#3 (permalink) |
|
Enthusiast Member
Join Date: May 2009
Location: New York
Posts: 293
Drives: 2009 370z 6MT
Rep Power: 17  |
I had a different code (PO300 error (cylinder misfire)), but the issue was the same. My idle wouldn't drop below 1.2k.
If you just installed the intake, I'd say give it a couple of days to give the ECU time to adjust to the increased airflow. If it's been more than a couple of days already, then I'd say re-check the hoses and clamps again. There has to be a leak somewhere, even if you cant see it. Try running the engine and spraying soapy water around the hoses, it'll show you if something isn't air tight.
__________________
Mods list and pics Click |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CEL Code - P2A00 | evse82 | Intake/Exhaust | 21 | 03-01-2012 05:53 PM |
| Code U1024 | Megan370z | Tuning | 9 | 03-15-2010 08:15 PM |
| How about this code reader? | Red370 | Nissan 370Z General Discussions | 16 | 01-05-2010 04:45 PM |
| Need Help - OBD code | jpit | Nissan 370Z General Discussions | 11 | 11-03-2009 06:44 PM |
| gas cap and cel(SES) code | tru_Asiatik | Engine & Drivetrain | 7 | 07-09-2009 11:38 AM |
Threaded Mode
