Replacement Performance Intake Manifold

-ZS-Carpenter · 06-25-2021, 03:04 AM

Quote:

Originally Posted by Rusty

The way to develop a manifold is with a flow bench. Start with the stock manifold and test it at different valve lifts ,cfm and velocities. Then test and retest the new manifold against what the stock manifold produced. Once you think you got it. Then it's time for the dyno.

And no one is going to cough up the coin to do that for a car that sold less than 100k units.

It is what it is on this platform. There will not be any ground breaking development done "the right way" because there is no profit in it. At best they will sell 20 parts if it works. FFS SOHO got what? 12 people on his manifold group buy.

There is no point in acting like everything has to be done like Nascar. It's a nissan that didn't sell well, thats it.

Sent from my SM-G965U using Tapatalk

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Intake manifold gasket replacement question	projectpanda	Intake/Exhaust	3	10-17-2018 12:19 PM
3" Short Intake + M370 Manifold vs 3" CAI + Z1 Manifold Dyno Comparison	MoncefVQ	Intake/Exhaust	11	02-26-2018 01:21 PM
R2c performance replacement panel filters - vq35hr, vq37vhr dual intake systems	Tunerz_Store	Exhaust/Intake	66	04-03-2017 04:00 PM
*Pre Order* AAM COMPETITION VQ37 PERFORMANCE INTAKE MANIFOLD	vividracing	Drivetrain/Engine	11	01-15-2016 04:02 PM
GTM Exhaust Manifold Replacement..?	COSMO	Forced Induction	10	03-19-2014 01:20 AM