|
Daelen can correct me if I am wrong but this would most likely perform better than oem with a light weight flywheel. If I'm not mistaken, the oem pulley is
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
10-23-2015, 12:56 PM
|
#11 (permalink) |
|
Enthusiast Member
 
Join Date: Jun 2013
Location: Huntsville, AL
Posts: 406
Drives: MB 370z
Rep Power: 13  |
Daelen can correct me if I am wrong but this would most likely perform better than oem with a light weight flywheel. If I'm not mistaken, the oem pulley is not a balancer, only a vibration damper as is the dual mass flywheel. If you remove the dual mass wheel then the vibration could increase. Adding this dampening pulley should help decrease the vibrations, especially at higher RPMs.
If you guys want a tester for this, I'll add myself to the list for the group buy and put one on with my sub 2lb clutch and lightweight steel flywheel. It will be one of the most light weight setup a Z will see. Last edited by derraj06; 10-23-2015 at 12:56 PM. Reason: iPhone nazi autocorrect sucks. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MA Motorsports Bolt in harness bar Group Buy! | MAMotorsports | Group Buys | 49 | 06-02-2016 03:32 PM |
| Z1 Motorsports Thermostatic Sandwich Plate kit (For Nissan Motorsports Oil Cooler) | Dustin@Z1 | Drivetrain/Engine | 3 | 06-08-2012 11:10 AM |
| [Showroom Motorsports] Rennen Forged Group Buy | Showroom Motorsports | Group Buys | 3 | 06-08-2011 02:51 PM |
| Z1 Motorsports Thermostatic Sandwich Plate kit (For Nissan Motorsports Oil Cooler) | Dustin@Z1 | Z1 Motorsports | 0 | 08-06-2010 11:26 AM |
43Likes
Threaded Mode
