Blown Motor, Engine Rebuild/Replacement.

COSMO

Any recommendations on a good lsd and what about the install? Is this a weekend job or does this require a professional ? I can honestly say I have done everything but a gear change, etc..

TBatt

The tricky part is to get the gear lash correct. Most of the time, the factory shims will get it right but if not you will have to take it back apart re-shim check and then repeat until right. Not real hard but time consuming and if you don't have the correct shims you got to get them. I'm doing what JWillis72 did, well almost, I'm taking the whole car to Z1 for the Quaife and then a dyno tune. That is, when I get the fuel pump replaced.........

__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!

B&W_Evader

OS Giken here. Best one in my opinion. Most expensive one too unfortunately. Like most people, I got lucky with the backlash and did not need to change shims.

DIY - Limited Slip Differential Install

__________________
|RIP|6spd-sport|OSG-LSD|XP8|RBF600|Eibach Sways|RE-71R|FI-34Row|Gen3-CAI|Yaw P.S.|