Stage II TT CEL Help!

VQStryker · 04-25-2012, 06:53 AM

Quote:

Originally Posted by SAM@GTM

P0103 Mass or Volume Air Flow Circuit High Input

I think your MAF sensor got wet especially if it was raining hard like you said in the email, clear the codes and look at both MAF voltages to see if they are even voltage wise. you Should see around.8 to .9 volt at idle . Rev the engine and see if the voltage is increasing smoothly. If all that is good then i think you got lucky and the sensor did not get damaged.

If the sensor got wet then there is a possibility that you might have still some water left in the intercooler, You should check and clean as needed .

Hope this help .

Sam

this is why I wanted you to data log the voltage and correction. Hopefully there is no damage, MAF sensors are not cheap by any means.

Thanks for the rep!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GMT stage 1 or 2	pokeyl	Forced Induction	78	03-10-2013 08:22 AM
[FOR SALE] Gtm stage 2 sc (g37)	kosstick	Parts for sale (Private Classifieds)	13	07-19-2012 10:37 AM
Stage 1 to Stage 1.5	Baer383	Forced Induction	10	03-01-2012 02:05 AM
GTM TT Stage 2	elperuano	Forced Induction	16	10-10-2011 07:48 AM
RGM Stage 1 (Need Some Help)	alexpila	Tuning	1	02-01-2010 11:09 AM