11-21-2010, 05:42 PM
|
#2 (permalink)
|
|
Track Member
Join Date: May 2010
Location: chesapeake va
Age: 41
Posts: 823
Drives: TT 370z Touring/SP
Rep Power: 18
|
Quote:
Originally Posted by xbigb4ller69z
I just Purchased a Ark Design Digital Unit. I am having some issues with the boost reading. Does anyone know where I would pick up boost reading?? It's connected to the MAF sensor, reading vaccuum and not getting any boost reading. The car does not have a boost controller.
|
Ok I don't know what you mean by it being connected to the Maf sensor? I am assuming that they did it like the directions said and there is a vaccuum line on the pipe that goes into your intake manifold. You can T it there and you should get a positive reading. Remember while ideling you are going to get a vacuum. In order to see if the guage is working properly you have to go drive the car. Just go down the street and romp it a little over 3k and you will see about 2 psi on that guage if you got it right. Just reving the engine wont show the boost as the turbos need the exhaust load to spool them up.
Frank
|
|
|
Similar Threads
Threaded Mode
