***Topgunz ROTREX C38R Supercharger Kit***

DrBacon

The failsafes actually have a way to cut ignition with a factory ecu? Because if I remember right those "failsafes" were just a little indicator light if the nozzle was spraying. That would not save your engine if it decided to fail mid pull, or at worse, human error in failure to verify everything is working every time you get into boost.

14Q60awdSPORT

The failsafe has a 0-5v output that you wire into your ecu the same as a flexfuel sensor/kit would, and when failsafe is triggered it will send a signal to the ecu and your tuner will setup the integration into the tune to have it automatically switch the tune to compensate if failure triggers. IE by adding more fuel, and pulling timing and/or reducing boost. Also the flow gauge tells you precisely when/if and exactly how many CC/min you are spraying as well to make it easy to verify and properly determine nozzle size.

The failsafe will trigger when flowing outside of your set CC/min flow range, pump failure, any electrical issues, wmi controller issues, clogged nozzles, leaky lines, or low fluid etc… pretty much any issues that could go wrong it can detect and automatically adjust tune (if tuner sets up in tune) to be safe if the system malfunctions/fails.

It also has a small light i always install by speedo cluster that will blink/flash indicating a failure, the WMI cc/min flow gauge will also flash. And they flash in various sequences to indicate which of the various failures where triggered.

This allows you to tune more aggressively without concerns.