|
http://www.the370z.com/forced-induct...-pulley-3.html This is a chart on impeller speed calculation...last time I talked to rotrex they confirmed the calculation as well .....and that is why GTM wouldn’t sell a pulley under
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-08-2018, 06:03 PM
|
#11 (permalink) |
|
Track Member
Join Date: Dec 2015
Location: South Carolina
Posts: 699
Drives: 2017 nismo 370z
Rep Power: 3376   |
88mm supercharger pulley
This is a chart on impeller speed calculation...last time I talked to rotrex they confirmed the calculation as well .....and that is why GTM wouldn’t sell a pulley under 86mm The 84mm is at 91280 at 7k rpm......a 80 mm would put you over 100k ... Also TOPGUN is correct ..if you blow the supercharger you could damage much more than just the bottom end .. we all take that risk when boosting but ....I wouldn’t go that far over specs on a blower I might be reading the charts wrong soooo ......im still not sure Last edited by Jinxx; 03-08-2018 at 06:36 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rotrex C38R & are HR/VHR GTM SC mounting brackets the same? | SS_Firehawk | Engine & Drivetrain | 6 | 02-09-2018 10:33 PM |
| Rotrex Oil Flow? | pokeyl | Forced Induction | 9 | 12-22-2015 08:55 AM |
| Rotrex pulley change | R3drckt09 | Forced Induction | 20 | 08-10-2014 08:35 AM |
| Replacement Rotrex Supercharger for the GTM Stage 1 kit | wind.zero | Forced Induction | 29 | 06-03-2014 06:20 AM |
| [FOR SALE] Rotrex C38-81 Supercharger Only | pokeyl | Parts for sale (Private Classifieds) | 3 | 02-17-2014 09:07 AM |
40Likes
Threaded Mode
