|
I have a similar setup with the oil cooler in a side vent, blowing through a hole in the fender. I only have one oil cooler, the Setrab 34 row.
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-14-2017, 02:41 AM
|
#7 (permalink) |
|
Base Member
Join Date: Aug 2014
Location: Los Angeles, CA.
Posts: 193
Drives: 08 G37S S/C
Rep Power: 40   |
I have a similar setup with the oil cooler in a side vent, blowing through a hole in the fender. I only have one oil cooler, the Setrab 34 row. Blowing air through the oil cooler works well, it's a good system. But in your proposed idea, I'd worry about the oil pump being able to run the oil through both of the coolers and the lines between them. Do you have a way to monitor your oil pressure? If so, monitor it before you put all the oil coolers on so you have a baseline.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Overheating problems/issues? | Quicksilvers | Engine & Drivetrain | 15 | 06-09-2017 06:51 PM |
| Problems overheating after installing some mods | erfan | Engine & Drivetrain | 13 | 07-06-2015 06:13 PM |
| Problems with Stillen Gen 3 | TonySlimfast | Nissan 370Z Roadster (Convertible) | 5 | 01-08-2013 10:38 AM |
| Problems installing Stillen CBE | Luna | Intake/Exhaust | 14 | 12-19-2010 12:02 PM |
| stillen g3 intakes? problems? | soshiro17 | Intake/Exhaust | 13 | 03-20-2010 05:44 PM |
Threaded Mode
