Comp turbo failure less than a mile

Rusty

I've worked on a lot of equipment that had pressed in zerk fittings. Had to replace a bunch of them too. Grease systems are not high pressure. Once you remove the gun. The pressure goes away. When greasing. Once you get the first fill of grease in. After that, you only need two to three pumps of new grease into the bearing. Any more then that. You CAN over grease the bearing and damage it. Some bearing housings will have a plug 180 degrees away from the zerk fitting. On these. You remove the plug and grease until you see some grease start to come out of the plug hole. When you do, stop greasing and install the plug.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html