BP turbo build/advice

Boosted Performance · 12-22-2018, 07:33 PM

Quote:

Originally Posted by hc_416

Hey guys,

Was back at it again. After i got the pump off i took the bottom plate off to see what happened. I see no shear pin? in one of the gears; and if im correct that is what attach's the gears to the pump!! is there anyway to just get the pump rebuilt? it seems if you replace the shear pin it should work. Any ideas or info?

https://imgur.com/a/mlcCwbi

There are no shear pins, there is a key to hold the gear on to the shaft as it rotates. It is not possible for the key to come out with the cover on, and the gear in place. It is not a large key, so it just slides down the square hole on the right gear. You can pull that gear out to inspect it.

Those gears look mint.

Did you pull the gears out at all? If the motor is running there is absolutely no reason for a rebuild. I have never seen one of these fail.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbo Build	davidson_z34	Forced Induction	33	11-12-2015 07:45 PM
Need Advice on Bottom End Build	604GZ	Engine & Drivetrain	5	04-07-2015 09:09 AM
Single turbo build	jlask370	Forced Induction	13	10-07-2013 12:41 PM
Need advice on stereo build....	mengel	Audio & Video	7	02-08-2011 08:24 AM