BP turbo build/advice

hc_416 · 04-21-2017, 06:22 PM

SOOOO>>>.<<<< here I am guys, going to need some help since i haven't done this before. I have one bov that is on the driver's side. I have two waste gates on the passengers side by the turbo. Unfortunately they ran the whole set up wrong so my brother and I have to redo it. They feed the BOV off a t that was coming of a vacuum on the back of the manifold; the other line was going to the boost controller. It also looks like they ran the waste gates off of separate t's. I will have to get the G reddy instruction and make sure to do it right. ..... They seem to have a t that they don't need. What I am gong to do is just rerun it. I do have a few questions if I can ask.

What my bother and I did today, was correct the bov by tapping the manifold and running a dedicated line for it. I have gotten to change out the spring yet so I still don't see vacuum. And on to the waste gates....I cant seem to get them to work. I have both ports on the waste-gates hooked up one line down with a t to the WG on the bottom side, and one line with a t coming back up. This is were I get confused. I have a greddy profec, which has a control box with a inline filter. a solonid with port 1 and 3 being used with port two with no plug and left open. I ran the control box line to the nipple on the charge pipe and put the lower WG line to port 3 and the upper WG line to port one. I did it wrong and I know just looking to get it right really need some help.... Thanks guys!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbo Build	davidson_z34	Forced Induction	33	11-12-2015 07:45 PM
Need Advice on Bottom End Build	604GZ	Engine & Drivetrain	5	04-07-2015 09:09 AM
Single turbo build	jlask370	Forced Induction	13	10-07-2013 12:41 PM
Need advice on stereo build....	mengel	Audio & Video	7	02-08-2011 08:24 AM

04-21-2017, 06:22 PM	#11 (permalink)
hc_416 Enthusiast Member Join Date: Aug 2013 Location: CT Posts: 254 Drives: g37 Rep Power: 12	SOOOO>>>.<<<< here I am guys, going to need some help since i haven't done this before. I have one bov that is on the driver's side. I have two waste gates on the passengers side by the turbo. Unfortunately they ran the whole set up wrong so my brother and I have to redo it. They feed the BOV off a t that was coming of a vacuum on the back of the manifold; the other line was going to the boost controller. It also looks like they ran the waste gates off of separate t's. I will have to get the G reddy instruction and make sure to do it right. ..... They seem to have a t that they don't need. What I am gong to do is just rerun it. I do have a few questions if I can ask. What my bother and I did today, was correct the bov by tapping the manifold and running a dedicated line for it. I have gotten to change out the spring yet so I still don't see vacuum. And on to the waste gates....I cant seem to get them to work. I have both ports on the waste-gates hooked up one line down with a t to the WG on the bottom side, and one line with a t coming back up. This is were I get confused. I have a greddy profec, which has a control box with a inline filter. a solonid with port 1 and 3 being used with port two with no plug and left open. I ran the control box line to the nipple on the charge pipe and put the lower WG line to port 3 and the upper WG line to port one. I did it wrong and I know just looking to get it right really need some help.... Thanks guys!