Supercharger cog belt being constantly chewed

Nut_N_Much

If you want to increase cooling in the intercooler take off the stock lines and add AN 12 fittings. Change out the fittings on the water res, intercooler and run the thicker lines to and from the pump and heat exchanger and your good. Replacement fitting is an NPT to AN. Can't remember the size but threads need to match the brass fitting you take off.

Also use distilled water and add some water wetter from Redline, will help keep temps down and keep calcium build up out of your system.

If you want to go to the next level. Relocate your battery to the trunk and add a Half gallon aluminum tank. It sits in the battery box and run the lines out of the fire wall the same way you normally would. One to the res (lowest point on container) on from heat exchanger (highest point on container) This will allow you to drop ICE in the res and run a cooler charge to the motor. I did this and it was awesome!!!!

Attached Images

	14409.jpg (69.8 KB, 13 views)
	IMG_0929.jpg (678.3 KB, 10 views)

__________________

Did new cool science stuff to the car !!!
http://www.the370z.com/mazoc/99606-z...y-14-17-a.html
http://www.the370z.com/diy-section-d...-w-videos.html