2011 370z with body problems

Vorttam · 07-05-2014, 10:21 PM

Alrighty, Sorry for the delay. Weekend after weekend just have not been able to do this project. 100% going to tackle this project tomorrow "sunday"
Thank you nevada3 for your input. I am hoping this is not the problem I am facing but it sure looks like it. Will have to see when I take this panel off.

Vorttam · 07-07-2014, 07:20 PM

Yay! All done. Was pretty easy to fix the side panel. Just needed to some new 3M tape in one area. The other spot towards the back of the panel the two clamps that hold it in place where broken off. Not sure how the hell that happen. That is why that part sticks out a little. It looks a little better.

Now on the the other area. The rear corner panel. This one I can not fig out why its not holding. After taking it a part to get access to the plastic clamp thing. It was not damaged at all. No cracking, all the hooks where fine. Nothing on it was broken. I do not understand why its not holding it correctly. I am thinking I will order a new one and see if that will correct it. I do not know. I took better angle picture.

This is the damaged side.

and compared to the normal side.

Also while I had the car jacked up I took a look under to see if everything looked normal. All was good till I saw this:

What could have caused that?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems starting 2011	mikerino	Engine & Drivetrain	6	06-03-2014 11:43 AM
370z problems	Joey1010	Nissan 370Z General Discussions	60	02-27-2014 07:25 AM
Problems with 370z	SuperTurbo	Nissan 370Z General Discussions	7	10-09-2012 10:03 AM
370Z gas cap door problems	freddiebear	Exterior & Interior	42	05-15-2010 09:31 AM
2011 Mustang GT cutom wide body	Minicobra1	Other Vehicles	16	01-19-2010 12:32 AM

07-05-2014, 10:21 PM	#1 (permalink)
Vorttam Base Member Join Date: Apr 2014 Location: Allen Posts: 46 Drives: 2011 370z 6MT Rep Power: 11	Alrighty, Sorry for the delay. Weekend after weekend just have not been able to do this project. 100% going to tackle this project tomorrow "sunday" Thank you nevada3 for your input. I am hoping this is not the problem I am facing but it sure looks like it. Will have to see when I take this panel off.

07-07-2014, 07:20 PM	#2 (permalink)
Vorttam Base Member Join Date: Apr 2014 Location: Allen Posts: 46 Drives: 2011 370z 6MT Rep Power: 11	Yay! All done. Was pretty easy to fix the side panel. Just needed to some new 3M tape in one area. The other spot towards the back of the panel the two clamps that hold it in place where broken off. Not sure how the hell that happen. That is why that part sticks out a little. It looks a little better. Now on the the other area. The rear corner panel. This one I can not fig out why its not holding. After taking it a part to get access to the plastic clamp thing. It was not damaged at all. No cracking, all the hooks where fine. Nothing on it was broken. I do not understand why its not holding it correctly. I am thinking I will order a new one and see if that will correct it. I do not know. I took better angle picture. This is the damaged side. and compared to the normal side. Also while I had the car jacked up I took a look under to see if everything looked normal. All was good till I saw this: What could have caused that?