2011 370z with body problems

kenchan

Nevada3

For the rear left bumper area it's very likely to be the BRACKET-REAR BUMPER SIDE,LH, Nissan part # 85013H, about $30 give or take. If the bumper is bumped hard enough in the right spot (perhaps by the previous owner) the plastic bracket that pulls the bumper close to the body will stay in place, but partially crack and slightly drift away from the body and end up looking like your bumper. See the attached pics for an example where the plastic around one of the connecting bolts broke off. You can access this part without fully removing the bumper, just remove all the bolts and snaps on the LH side of the car and the snap just below the rear fog and you can get enough clearance. If you want to be really careful you can remove the entire bumper, it just takes longer.

For a second view, take a look at NickTurnon's car below (see his build link here NickTurnon's 370z Build). On his silver Z the bracket is white in color. You can see where the bracket is located here:

Attached Images

	Nissan 85013H Pic 1.jpg (492.9 KB, 13 views)
	Nissan 85013H Pic 2.jpg (541.8 KB, 9 views)

Nevada3

The sill cover may have more going on. If you look carefully, the gap between the door and metal body panel looks like it narrows a decent amount and there isn't a lot you can do about that. See the attached pictures to get an idea of what the gap should look like from the factory. Can you open the door and take a few photos where the door sill meets the metal body panel?

Attached Images

	Nissan door to sill cover gaps Pic 1.jpg (466.0 KB, 20 views)
	Nissan door to sill cover gaps Pic 2.jpg (392.5 KB, 12 views)