EVO-R Carbon Fiber front lip - Preview Teaser

EVOR

Guys I want to make this install as detail as possible. Cuz if you don't do it right one of other parts will not fit right. First I put on 3M double sides on the center bumper. (Make sure youe have clean the surface before this) Follow the line of the bumper. This is important.

Make the center top edge of the font lip line up with 3Mdouble side line. Then put on the sides of the center lip part. Make sure push in hard so that there will be no gaps. Use the provided screw screw on the bottom part.

Put on 3M double side on the edge top of the side lip cover.

Alos put ome on the area where it meets the center lip.
Line up with factory bumper line for the lower lip. You will see how it flows. Do the center section first so that the cover will colse with the bumper with no gap.
[img]http://a.imageshack.us/img153/4522/img4027c.jpg[/img[
The do the sides. If you see your edges of the bumper and the side cover has a gap, that means you did not line up correctly, push the sode cover more to the center. Screw 2 screws on the edge of the side cover to the bumper.

Screw on the bottom section of the side cover.

Do the same for the other side. Does not matter which side you do it first. Main point is when you put them on make sure there is no gaps and follow the line of the bumper.

__________________
WWW.EVO-R.NET