STILLEN 370Z Urethane Fascia - Sneak Peek - In Development

Kyle@STILLEN · 02-24-2010, 12:22 PM

We put A LOT of work into this kit guys!!!

First off, we wanted to make sure that the fascia did not cost an arm and a leg just to ship. So, we have made this a three piece kit. The top corners are flanged and can either be molded in or a small body line will appear under the headlights. We will be working on extremely detailed instructions and possibly an instructional DVD on how to do the molding pat. Either way it will be very secure.

Basically if we did not design the fascia this way it would have been required to be shipped truck freight and would cost an additional 200-300 dollars to ship and even more if the part was shipped to a residence. By making these small changes we are able to ship via Fedex ground service and drastically reduce the freight costs for you guys.

The molds are being cleaned right now and will be run late this week like Josh said.

RCZ- The additional oil cooler has been developed and we will have all of the bracketry ready very soon.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Carbon Fiber front fascia?	kannibul	Exterior & Interior	21	09-30-2009 01:19 AM
front fascia cost?	Snakes709	Nissan 370Z General Discussions	7	09-22-2009 07:15 AM
Sneak Peek, Carbon Fiber B-Pillars @ The 370ZSOURCE!!!	Michael@TheZStore	Exterior & Interior	3	08-25-2009 05:21 PM
Sneak Peek, Carbon Fiber Door Sills @ The 370ZSOURCE!!!!!	Michael@TheZStore	Exterior & Interior	2	07-29-2009 03:58 PM
Going to sneak a peek at a 2010 Genesis Coupe in a few minutes!!!	iamtherhino	Other Vehicles	5	03-07-2009 10:08 AM

02-24-2010, 12:22 PM	#11 (permalink)
Kyle@STILLEN The370Z.com Sponsor Join Date: Dec 2008 Location: Newport Beach Posts: 626 Drives: Toyota Tundra Rep Power: 308	We put A LOT of work into this kit guys!!! First off, we wanted to make sure that the fascia did not cost an arm and a leg just to ship. So, we have made this a three piece kit. The top corners are flanged and can either be molded in or a small body line will appear under the headlights. We will be working on extremely detailed instructions and possibly an instructional DVD on how to do the molding pat. Either way it will be very secure. Basically if we did not design the fascia this way it would have been required to be shipped truck freight and would cost an additional 200-300 dollars to ship and even more if the part was shipped to a residence. By making these small changes we are able to ship via Fedex ground service and drastically reduce the freight costs for you guys. The molds are being cleaned right now and will be run late this week like Josh said. RCZ- The additional oil cooler has been developed and we will have all of the bracketry ready very soon.