Covering the Safety Warning on the Visors

scottIN

I did it with 3M DiNoc. I did a write up somewhere on here, but here's the quick version: measure and cut just a little larger than the area. Peel off the backing and lightly attach it, then run your finger along the edges (down in the groove). That will give you a line to cut on. Remove, trim with scissors and reapply. The edges should fit down in the little valley so it looks clean (vs. seeing an edge). I found that the warning stickers aren't perfectly square - that's why you sort of have to make a template for them to get the edges to tuck in.