Covering the Safety Warning on the Visors

HulaGirl

Good idea. Is there already adhesive on the CF vinyl? If not, adhesive recommendations?

__________________
~*Hula Girl at Heart*~
Rear Deck Spoiler, Splash Guards, AFE filters, Weathertech Liners, Xpel, Calipers in VHT Bright Blue, Clazzio Seatcovers

Chuck33079

It was self adhesive, but I scuffed up the warning sticker a bit and used some adhesion promoter so it wouldn't come off.

__________________
2011 MB Touring-Sport-6sp-Nav/GTM TT/FI TT TDX/JTran/Kosmic/Eibach/Hotchkis/SPC/CSF/RPS/SoThatsWhereAllMyMoneyWent

scottIN

I did it with 3M DiNoc. I did a write up somewhere on here, but here's the quick version: measure and cut just a little larger than the area. Peel off the backing and lightly attach it, then run your finger along the edges (down in the groove). That will give you a line to cut on. Remove, trim with scissors and reapply. The edges should fit down in the little valley so it looks clean (vs. seeing an edge). I found that the warning stickers aren't perfectly square - that's why you sort of have to make a template for them to get the edges to tuck in.