|
The M77 grease is to be applied to the flat face of the outer CV only. Not the splines. The flat face is the face which butts up against the
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
02-17-2016, 09:39 AM
|
#10 (permalink) |
|
Enthusiast Member
Join Date: Nov 2012
Location: Sydney
Posts: 428
Drives: 11 Nissan 370Z MB M6
Rep Power: 139   |
The M77 grease is to be applied to the flat face of the outer CV only. Not the splines. The flat face is the face which butts up against the hub. It's approx 10mm wide. There is a TSB for the 370Z and many Nissan models. The TSB will
have photos that tell you where to put the grease. Follow the specified amount - weigh the tube using digital scales before applying and during application to determine when you have administered enough grease. From memory, i took the axles out to do the greasing because i couldnt get enough room to properly see where i was applying it. Dont take chances, order the mandatory replacement fasteners As i said earlier, this did not solve my problem but by all means try it out if you have access to the grease. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Axle Clunk (Please Report Here!) | RedZed34 | Engine & Drivetrain | 102 | 01-23-2017 04:51 PM |
| Attention Owners of 2010 370Z - Clunk Noise from Rear of Vehicle | jgalloner | Nissan 370Z General Discussions | 50 | 10-22-2016 03:43 PM |
| Rear coil sitting lower, slight click/clunk noise | NOFATCHX | Brakes & Suspension | 9 | 05-24-2013 11:48 AM |
| axle click? | ak808 | Brakes & Suspension | 9 | 01-28-2013 10:55 AM |
| Noise in 1st/2nd - NOT clunk, clank, whine | Davey | Engine & Drivetrain | 8 | 05-16-2011 01:44 PM |
133Likes
Threaded Mode
