Jun camshaft .. Help !!

1slow370 · 06-04-2014, 12:22 PM

Quote:

Originally Posted by Elmo370z

Yes you can run stock compression, I'm pretty sure some stated the cams were intended to be used in a 100% stock motor, and you will see 15-20 horsepower from just that mod alone. But I think you have to reset the vvel.

You will also have check the clearance between the cams and lifters to make sure they are in spec. If you don't best case is it didn't change, worse case there isn't enough clearance and you will melt something or run a valve into a piston, or if there is to much clearance it will slap around in there and either just break, or damage the cam from the pounding.

Edit: just so you know you need to do this any time you change cams, even if you put in another oe cam, it is best to do it whenever the head or block is decked as well in case the head gets distorted, basically any time you pull the head you should check it, it only takes 30 minutes.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
any word on NISMO R-TUNE camshaft upgradres?	need4speed	Engine & Drivetrain	6	09-10-2009 03:39 PM